:SBUS<n> Commands 24
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 465
:SBUS<n>:MODE
(see page 798)
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {CAN | IIC | LIN | SPI | UART}
The :SBUS<n>:MODE command determines the decode mode for the serial bus.
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode setting.
Return Format
<mode><NL>
<mode> ::= {CAN | IIC | LIN | SPI | UART | NONE}
Errors • "-241, Hardware missing" on page 759
See Also • "Introduction to :SBUS<n> Commands" on page 461
• ":SBUS<n>:CAN Commands" on page 466
• ":SBUS<n>:IIC Commands" on page 483
• ":SBUS<n>:LIN Commands" on page 493
• ":SBUS<n>:SPI Commands" on page 507
• ":SBUS<n>:UART Commands" on page 523
This command is only valid when a serial decode option has been licensed. The CAN, LIN, and
SPI serial decode and triggering options are available on the DSOX1000-Series oscilloscope
models.
To Next Page
Loading...
Need help?
General
