360 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
20 :MEASure Commands
90%, 50%, and 10% values between Vbase and Vtop. If you want to move the
delay measurement point nearer to Vtop or Vbase, you must change the threshold
values with the :MEASure:DEFine THResholds command.
Return Format
<value><NL>
<value> ::= floating-point number delay time in seconds in NR3 format
See Also • "Introduction to :MEASure Commands" on page 350
• ":MEASure:DEFine" on page 356
• ":MEASure:PHASe" on page 372
To Next Page
Loading...
