Acquisition and waveform setupMXO 4 Series
112User Manual 1335.5337.02 ─ 07
Figure 6-2: Acquisition settings: manual sample rate and record length
Run/Stop
Starts and stops the continuous acquisition. The [Run / Stop] key lights green when the
acquisition is running. When the acquisition is stopped, the key lights red.
Remote command:
RUN on page 505
STOP on page 505
Run Single
Starts a defined number of acquisitions. The [Single] key lights green when the acquisi-
tion is running. When the acquisition is stopped, the key lights red.
To set the number of acquisitions, set "N-single/Avg count" in the "Acquisition" setup.
The acquisition progress is shown in the acquisition label, see "Progress information"
on page 72.
Remote command:
SINGle on page 505
SR mode
Defines how the sample rate is set.
Acquisition
To Next Page
Loading...
