Rohde & Schwarz MXO 4 Series - Page 113

Acquisition and waveform setupMXO 4 Series
113User Manual 1335.5337.02 ─ 07
The sample rate considers the samples of the ADC, and the processing of the cap-
tured samples including interpolation.
"Auto"
Sample rate is determined automatically and changes due to instru-
ment internal adjustments due to other setting changes. You can set
a minimum sample rate with Min. sample rate.
"Manual"
The sample rate is manually defined with Sample rate.
Remote command:
ACQuire:SRATe:MODE on page 519
Min. sample rate
Sets the minimum value of the sample rate for calculation in automatic sample rate
mode.
Remote command:
ACQuire:SRATe:MINimum on page 519
Sample rate
Sets the number of waveform points per second in manual sample rate mode.
Remote command:
ACQuire:SRATe[:VALue] on page 519
RL mode
Selects the mode of the waveform record length adjustment.
The record length is the number of waveform samples that are stored in one waveform
record after processing, including interpolation. It determines the length of the dis-
played waveform.
"Auto"
Record length is determined automatically and changes due to instru-
ment internal adjustments due to other setting changes. You can set
a maximum record length with Record length limit.
"Manual"
The waveform record length is manually defined with Record length.
Remote command:
ACQuire:POINts:MODE on page 518
Record length limit
Sets the maximum value of the record length for calculation in automatic record length
mode.
Remote command:
ACQuire:POINts:MAXimum on page 518
Record length
Sets the record length in manual record length mode.
Remote command:
ACQuire:POINts[:VALue] on page 517
N-single/Avg count
The acquisition and average count has several effects:
●
It sets the number of waveforms acquired with [Single].
Acquisition