Rohde & Schwarz MXO 4 Series - Page 158

TriggerMXO 4 Series
158User Manual 1335.5337.02 ─ 07
The interval trigger can analyze either rising or falling edges, but searching for an inter-
val is also possible for both edges at the same time ("Either").
This section describes the trigger-type specific settings. For settings that apply to all
trigger types, see Chapter 7.2, "Common trigger settings", on page 142.
Level
See "Level" on page 143.
Remote command:
TRIGger:EVENt<ev>:LEVel<n>[:VALue] on page 541
Slope
Sets the edge for the trigger. You can analyze the interval between positive edges or
between negative edges.
Remote command:
TRIGger:EVENt<ev>:INTerval:SLOPe on page 556
Range
Selects how the range of an interval is defined:
"Within"
Triggers on pulse intervals inside a given range. The range is defined
by "Interv. width" and "±Delta".
"Outside"
Triggers on intervals outside a given range. The range definition is
the same as for "Within" range.
Trigger types