Rohde & Schwarz MXO 4 Series - Page 162

TriggerMXO 4 Series
162User Manual 1335.5337.02 ─ 07
Data source
Selects the input channel of the data signal.
Remote command:
TRIGger:EVENt<ev>:SOURce on page 542
Level
Sets the voltage level for the data signal. At this level, the setup and hold time are
measured.
Remote command:
TRIGger:EVENt<ev>:LEVel<n>[:VALue] on page 541
Clock source
Selects the input channel of the clock signal.
Remote command:
TRIGger:EVENt<ev>:SETHold:CSOurce[:VALue] on page 560
Clock edge
Sets the edge of the clock signal. Edge and level define the time reference point.
Trigger types