Rohde & Schwarz MXO 4 Series - Page 258

ApplicationsMXO 4 Series
258User Manual 1335.5337.02 ─ 07
FRA plot result table
In the FRA plot result table, all sample points are displayed with the respective value
for the frequency, gain, phase and amplitude. If you select a sample in the table, the
respective points in the FRA plot are highlighted by a white vertical helper line on the
gain and the phase curve.
Marker value table
There are two markers available for the FRA plot. They are highlighted on the FRA plot
diagram by a white line and the respective marker number 1 or 2. You can move the
markers as needed.
In the marker table you can see the frequency, phase and gain values for both of them.
Remote commands:
●
FRANalysis:MARKer<m>:FREQuency on page 674
●
FRANalysis:MARKer<m>:GAIN? on page 674
●
FRANalysis:MARKer<m>:PHASe? on page 674
Margin value table
The margin value displays the gain and the phase margin frequency and value of the
system. Higher margin values are an indicator for higher stability of the system.
Remote commands:
●
FRANalysis:MARGin:STATe on page 672
●
FRANalysis:MARGin:GAIN:FREQuency? on page 673
●
FRANalysis:MARGin:GAIN:VALue? on page 673
●
FRANalysis:MARGin:PHASe:FREQuency? on page 673
●
FRANalysis:MARGin:PHASe:VALue? on page 673
Frequency response analysis (option R&S
MXO4-K36)