Mixed signal option (MSO, R&S MXO4-B1)MXO 4 Series
423User Manual 1335.5337.02 ─ 07
State
Enables the selected logic group. The corresponding signal icon appears on the signal
bar.
If another active bus already uses the same digital channel, the instrument disables the
other bus and shows a message.
Remote command:
PBUS<pb>:STATe on page 852
Show dig. signals
If enabled, the selected digital channels are shown in the diagram. Each channel is dis-
played as a logic signal.
Remote command:
PBUS<pb>:DISPlay:SHDI on page 851
Logic configuration
To Next Page
Loading...
