Rohde & Schwarz MXO 4 Series - Page 558

Remote control commandsMXO 4 Series
558User Manual 1335.5337.02 ─ 07
<n> 1 to 4, index of the analog channel
Parameters:
<Level> Range: -10 to 10
Increment: 0.001
*RST: 0.1
Default unit: V
Usage: Asynchronous command
Manual operation: See "Upper level" on page 160
TRIGger:EVENt<ev>:SLEW:DELTa
<TimeDelta>
Defines a time range around the given slew rate.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<TimeDelta> Range: 0 to 10
Increment: 1E-07
*RST: 0
Default unit: s
Usage: Asynchronous command
Manual operation: See "±Delta" on page 161
TRIGger:EVENt<ev>:SLEW:RANGe <RangeMode>
Selects how the time limit for the slew rate is defined. The time measurement starts
when the signal crosses the first trigger level - the upper or lower limit depending on
the selected slope. The measurement stops when the signal crosses the second level.
You can select the rate with TRIGger:EVENt<ev>:SLEW:RATE and set the delta with
TRIGger:EVENt<ev>:SLEW:DELTa.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<RangeMode> INSRange | OUTRange | LTHan | GTHan
INSRange
Triggers on pulses inside a given range. The range is defined by
the slew rate ±delta.
OUTRange
Triggers on pulses outside a given range. The range is defined
by the slew rate ±delta.
LTHan
Triggers on pulses shorter than the given slew rate.
GTHan
Triggers on pulses longer than the given slew rate.
Trigger