Rohde & Schwarz MXO 4 Series - Page 576

Remote control commandsMXO 4 Series
576User Manual 1335.5337.02 ─ 07
LAYout<ly>:ZOOM<zo>:HORizontal:ABSolute:WIDTh <Span>
Defines the width of the zoom area in absolute values.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<zo> 1...4, index of the zoom
Parameters:
<Span> Range: 0 to 1E+26
Increment: 0.01
*RST: 0.01
Default unit: Depends on the underlying waveform
Usage: Asynchronous command
LAYout<ly>:ZOOM<zo>:HORizontal:MODE <Mode>
Defines if absolute or relative values are used to specify the x-axis values. Since the
zoom area refers to the active signal, relative values ensure that the zoom area
remains the same.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<zo> 1...4, index of the zoom
Parameters:
<Mode> ABS | REL
*RST: ABS
Example: See Chapter 17.4.1, "SmartGrid layout with zoom", on page 474.
Usage: Asynchronous command
Manual operation: See "Mode" on page 180
LAYout<ly>:ZOOM<zo>:HORizontal:RELative:POSition <RelativeCenter>
Defines the x-value of the centerpoint of the zoom area in relative values.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<zo> 1...4, index of the zoom
Parameters:
<RelativeCenter> Relative position of the centerpoint (x-value)
Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Usage: Asynchronous command
Waveform analysis