Rohde & Schwarz MXO 4 Series - Page 583

Remote control commandsMXO 4 Series
583User Manual 1335.5337.02 ─ 07
Operation <Expression> Comment
Derivation "Derivation(C1,NoiseReject)" NoiseReject can get any value
between 1 and 5000 points
Default = 50
Integral "Integral(C1)"
Logarithm (based on
10)
"Log(C1)" Uses the absolute value of the source
in calculation.
Log(0) = Clip -
Natural logarithm
(based on e)
"Ln(C1)" Uses the absolute value of the source
in calculation.
Log(0) = Clip -
Binary logarithm
(based on 2)
"Ld(C1)" Uses the absolute value of the source
in calculation.
Log(0) = Clip -
Square "Pow(C1)"
Square root "Sqrt(C1)" Uses the absolute value of the source
in calculation.
Rescale "Rescale(C1,a,b)" a = scale, default = 1
b = offset, default = 0
FIR "FIR(Type,C1,Cut-Off,Characteristics)"
Examples:
"FIR(highpass,C1,10000000,Gaussian)"
"FIR(lowpass,C1,10000000,rectangle)"
Type = lowpass, highpass
Cut-Off = limit frequency
Characteristics = Gaussian, rectangle
Cut-Off can get any value between
4 GHz and 1 kHz
Suffix:
<m>
.
1...5, index of the math waveform
Parameters:
<Expression> String with regular expression for calculation
Example:
CALC:MATH 'C1*C2'
Defines the multiplication of waveforms channel 1 and channel
2.
Usage: Asynchronous command
Manual operation: See "Operator" on page 184
CALCulate:MATH<m>:LABel <Label>
Defines a label for the selected math waveform.
Suffix:
<m>
.
1...5, index of the math waveform
Parameters:
<Label> String with the label
Waveform analysis