Rohde & Schwarz MXO 4 Series - Page 697

Remote control commandsMXO 4 Series
697User Manual 1335.5337.02 ─ 07
TWENty
20/50/80
USER
Set the reference levels to individual values with POWer<m>:
QUALity:REFLevel<rl>:RELative:LOWer, POWer<m>:
QUALity:REFLevel<rl>:RELative:MIDDle, and
POWer<m>:QUALity:REFLevel<rl>:RELative:UPPer.
*RST: TEN
Usage: Asynchronous command
Manual operation: See "Relative levels" on page 286
POWer<m>:HARMonics:REFLevel<rl>:RELative:UPPer <UppRefLevRel>
POWer<m>:QUALity:REFLevel<rl>:RELative:UPPer <UppRefLevRel>
Sets the upper relative reference level if POWer<m>:QUALity:REFLevel<rl>:
RELative:MODE on page 696 is set to USER.
Suffix:
<m>
.
1...3, index of the power analysis measurement
<rl> 1...4, index of the reference level set
Parameters:
<UppRefLevRel> Range: -100 to 200
Increment: 1
*RST: 90
Default unit: %
Usage: Asynchronous command
Manual operation: See "Upper level, Middle level,Lower level" on page 286
17.15.2.5 Power analysis data
This chapter describes the commands for exporting and loading power analysis mea-
surement data.
POWer<m>:HARMonics:POWer:DATA:HEADer?.............................................................. 697
POWer<m>:QUALity:POWer:DATA:HEADer?................................................................... 698
POWer<m>:HARMonics:POWer:DATA[:VALues]...............................................................698
POWer<m>:QUALity:POWer:DATA[:VALues]?.................................................................. 699
POWer<m>:HARMonics:POWer:DATA:HEADer?
Returns the header of the power analysis waveform data. The header contains attrib-
utes of the waveform.
Suffix:
<m>
.
1...3, index of the power analysis measurement
Applications