Rohde & Schwarz MXO 4 Series - Page 831

Remote control commandsMXO 4 Series
831User Manual 1335.5337.02 ─ 07
Manual operation: See "Check all, Clear, Invert, Reset" on page 416
SBUS<sb>:TNOS:FILTer:CLR
Disables the filter for all available frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 416
SBUS<sb>:TNOS:FILTer:RST
Resets the state of the selected frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 416
SBUS<sb>:TNOS:FILTer:INVert
Inverts the current state of the frame and error types: all frames and error types that
were enabled are disabled and vice versa.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 416
SBUS<sb>:TNOS:FILTer:BIT <Frame>,<Field>,<Bit>
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:BIT <BitState>
Sets the operator for the data pattern in the selected field of the selected frame.
Suffix:
<sb>
.
1...4, index of the serial bus
<fr> index of the frame
<fl> index of the field
Parameters:
<BitState> ONE | ZERO
*RST: ZERO
Protocols