Rohde & Schwarz MXO 4 Series - Page 848

Remote control commandsMXO 4 Series
848User Manual 1335.5337.02 ─ 07
Suffix:
<pb>
.
1...4, index of the logic group
<n> 0..15
Selects the bit of the bus word. Each bit corresponds to a digital
channel.
Parameters:
<Assigned> ON | OFF
*RST: OFF
Usage: Asynchronous command
PBUS<pb>:CLEar
Removes all assigned digital channels from the bus.
Suffix:
<pb>
.
1...4, index of the logic group
Usage: Setting only
Asynchronous command
PBUS<pb>:CLOCk <ClockSource>
Selects the digital channel used as clock.
Suffix:
<pb>
.
1...4, index of the logic group
Parameters:
<ClockSource> D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 |
D13 | D14 | D15
Clock channel
*RST: D0
Usage: Asynchronous command
Manual operation: See "Clock source" on page 426
PBUS<pb>:CLON <Clocked>
Defines if the bus is a clocked bus - one of the digital channels serves as clock of the
bus.
Suffix:
<pb>
.
1...4, index of the logic group
Parameters:
<Clocked> ON | OFF
*RST: OFF
Usage: Asynchronous command
Mixed signal option (option R&S MXO4-B1)