Power analysis (option R&S RTE-K31)
R&S
®
RTE
1010User Manual 1326.1032.02 ─ 20
Mea
s.
type
Symbol Description/Result
Pos.
duty
cycle
R
PosCyc
Positive duty cycle: Width of a positive pulse in relation to the
period in %. The measurement requires at least one complete
period of a triggered signal. Multiple measurements are possi-
ble.
%100
Period
PosPulse
PosCyc
T
T
R
Neg.
duty
cycle
R
NegCyc
Negative duty cycle: Width of a negative pulse in relation to the
period in %. The measurement requires at least one complete
period of a triggered signal. Multiple measurements are possi-
ble.
%100
Period
NegPulse
NegCyc
T
T
R
"Ripple" is a statistical evaluation that is reset only if the measurement setup is
changed or you reset the statistics.
The following remote commands are used for handling the measurement results:
●
POWer:RIPPle:RESult:FREQuency:AVG? on page 1974
●
POWer:RIPPle:RESult:FREQuency:EVTCount? on page 1974
●
POWer:RIPPle:RESult:FREQuency:NPEak? on page 1974
●
POWer:RIPPle:RESult:FREQuency:PPEak? on page 1974
●
POWer:RIPPle:RESult:FREQuency:RMS? on page 1974
●
POWer:RIPPle:RESult:FREQuency:STDDev? on page 1974
●
POWer:RIPPle:RESult:FREQuency:WFMCount? on page 1974
●
POWer:RIPPle:RESult:FREQuency[:ACTual]? on page 1974
●
POWer:RIPPle:RESult:MAXimum:AVG? on page 1974
●
POWer:RIPPle:RESult:MAXimum:EVTCount? on page 1974
●
POWer:RIPPle:RESult:MAXimum:NPEak? on page 1974
●
POWer:RIPPle:RESult:MAXimum:PPEak? on page 1974
●
POWer:RIPPle:RESult:MAXimum:RMS? on page 1974
●
POWer:RIPPle:RESult:MAXimum:STDDev? on page 1974
●
POWer:RIPPle:RESult:MAXimum:WFMCount? on page 1974
●
POWer:RIPPle:RESult:MAXimum[:ACTual]? on page 1974
●
POWer:RIPPle:RESult:MINimum:AVG? on page 1975
●
POWer:RIPPle:RESult:MINimum:EVTCount? on page 1975
●
POWer:RIPPle:RESult:MINimum:NPEak? on page 1975
●
POWer:RIPPle:RESult:MINimum:PPEak? on page 1975
●
POWer:RIPPle:RESult:MINimum:RMS? on page 1975
●
POWer:RIPPle:RESult:MINimum:STDDev? on page 1975
●
POWer:RIPPle:RESult:MINimum:WFMCount? on page 1975
Output
To Next Page
Loading...
