Protocol analysis
R&S
®
RTE
614User Manual 1326.1032.02 ─ 20
Remote command:
●
BUS<m>:FORMat on page 1422
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands are described in Chapter 18.17.7.3, "Decode results",
on page 1538.
13.6.6 Search on decoded LIN data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 445.
13.6.6.1 LIN search setup
Access: [SEARCH] > "Setup" tab
LIN (option R&S RTE-K3)
To Next Page
Loading...
