Rohde & Schwarz RTE Series - Decode Results

Remote control commands
R&S
®
RTE
1571User Manual 1326.1032.02 ─ 20
Parameters:
<CRCPayloadError> ON | OFF
*RST: ON
18.17.8.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1422
●
BUS<m>:SYMBols on page 1423
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1421
BUS<m>:FLXRay:FCOunt?.......................................................................................... 1571
BUS<m>:FLXRay:FRAMe<n>:STATus?......................................................................... 1571
BUS<m>:FLXRay:FRAMe<n>:STARt?...........................................................................1572
BUS<m>:FLXRay:FRAMe<n>:STOP?............................................................................1572
BUS<m>:FLXRay:FRAMe<n>:SYMBol?.........................................................................1572
BUS<m>:FLXRay:FRAMe<n>:TYPE?............................................................................1573
BUS<m>:FLXRay:FRAMe<n>:DATA?............................................................................ 1573
BUS<m>:FLXRay:FRAMe<n>:FLAGs?.......................................................................... 1574
BUS<m>:FLXRay:FRAMe<n>:ADID?.............................................................................1574
BUS<m>:FLXRay:FRAMe<n>:PAYLength?.................................................................... 1574
BUS<m>:FLXRay:FRAMe<n>:CYCount?....................................................................... 1575
BUS<m>:FLXRay:FRAMe<n>:CSSTate?........................................................................1575
BUS<m>:FLXRay:FRAMe<n>:CSValue?........................................................................1575
BUS<m>:FLXRay:FRAMe<n>:FCSTate?........................................................................1576
BUS<m>:FLXRay:FRAMe<n>:FCValue?........................................................................1576
BUS<m>:FLXRay:FCOunt?
Returns the number of decoded frames.
Suffix:
<m>
.
1..4
Selects the serial bus.
Return values:
<Count> Returns the number of decoded frames.
Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:FLXRay:FRAMe<n>:STATus?
Returns the overall state of the selected frame.
Protocols