Rohde & Schwarz RTE Series - Starting and Stopping Acquisition

Remote control commands
R&S
®
RTE
1107User Manual 1326.1032.02 ─ 20
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
● Starting and stopping acquisition........................................................................ 1107
● Time base............................................................................................................1108
● Acquisition........................................................................................................... 1113
● Fast segmentation...............................................................................................1115
● Vertical.................................................................................................................1116
● Waveform data.................................................................................................... 1121
● Probes.................................................................................................................1123
● R&S RT-ZVC probe.............................................................................................1143
● Differential signals...............................................................................................1157
● Digital filter...........................................................................................................1160
● Skew....................................................................................................................1161
● High definition mode............................................................................................1162
● Reference clock...................................................................................................1163
18.8.1 Starting and stopping acquisition
RUNContinous.............................................................................................................1107
RUN........................................................................................................................... 1107
RUNSingle.................................................................................................................. 1107
SINGle........................................................................................................................1107
STOP..........................................................................................................................1107
RUNContinous
RUN
Starts the continuous acquisition.
Usage:
Event
Asynchronous command
RUNSingle
SINGle
Starts a defined number of acquisition cycles. The number of cycles is set with
ACQuire:COUNt.
Usage:
Event
Asynchronous command
STOP
Stops the running acquistion.
Acquisition and setup