Rohde & Schwarz RTE Series - Overview of Power Measurement Setup

Power analysis (option R&S RTE-K31)
R&S
®
RTE
964User Manual 1326.1032.02 ─ 20
Measurement Setup
Adds a graphic of the measurement setup.
Remote command:
POWer:REPort:CONTent:MSETup on page 1946
Settings
Adds the settings of the analysis.
Remote command:
POWer:REPort:CONTent:SETTings on page 1946
Vertical Setup
Adds the vertical setup settings.
Remote command:
POWer:REPort:CONTent:VSETup on page 1946
Trigger Setup
Adds the trigger setup settings.
Remote command:
POWer:REPort:CONTent:TSETup on page 1946
Horizontal Setup
Adds the horizontal setup settings.
Remote command:
POWer:REPort:CONTent:HSETup on page 1946
Measured signals
Adds a diagram of the measured signal.
Remote command:
POWer:REPort:CONTent:MSIGnal on page 1946
Results
Adds the result box.
Remote command:
POWer:REPort:CONTent:RESU on page 1946
16.2 Overview of power measurement setup
Each power analysis measurement dialog box consists of the following tabs:
●
Channels
●
Settings
●
Details
At the bottom of each tab, you can find two buttons. Tapping "Power Menu", you can
return to the power analysis measurement selection. "Execute" starts the power mea-
surement.
Overview of power measurement setup