Rohde & Schwarz RTE Series - Configuration; I²C (Option R&S RTE-K1)

Remote control commands
R&S
®
RTE
1426User Manual 1326.1032.02 ─ 20
18.17.3 I²C (option R&S RTE-K1)
● Configuration.......................................................................................................1426
● Trigger.................................................................................................................1428
● Decode results.................................................................................................... 1434
● I²C search settings.............................................................................................. 1443
● I²C search results................................................................................................1451
18.17.3.1 Configuration
BUS<m>:I2C:SCL:SOURce.......................................................................................... 1426
BUS<m>:I2C:SDA:SOURce..........................................................................................1426
BUS<m>:I2C:SCL:THReshold.......................................................................................1427
BUS<m>:I2C:SDA:THReshold.......................................................................................1427
BUS<m>:I2C:TECHnology............................................................................................1427
BUS<m>:I2C:RWBit..................................................................................................... 1428
BUS<m>:I2C:SCL:SOURce <SCLSource>
Sets the waveform of the clock line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SCLSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
Digital and analog channels cannot be used at the same time for
data and clock lines.
See Chapter 18.4.2, "Waveform parameter", on page 1074
*RST: C2W1
Usage: Asynchronous command
BUS<m>:I2C:SDA:SOURce <SDASource>
Sets the waveform of the data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Protocols