Rohde & Schwarz RTE Series - Pattern

Search functions
R&S
®
RTE
458User Manual 1326.1032.02 ─ 20
Clock source, Clock edge
Define the clock settings. The clock signal is the waveform to be searched.
Remote command:
SEARch:TRIGger:STATe:CSOurce on page 1376
SEARch:TRIGger:STATe:CEDGe on page 1376
SEARch:TRIGger:STATe:CLEVel on page 1376
State pattern
State settings are the same as for the state trigger.
See also "Pattern" on page 256.
Remote command:
SEARch:TRIGger:STATe:A[:ENABle] on page 1377
SEARch:TRIGger:STATe:A:LOGic on page 1377
SEARch:TRIGger:STATe:AB:LOGic on page 1378
SEARch:TRIGger:STATe:ABCD:LOGic on page 1378
11.2.2.11 Pattern
The pattern search combines a logical combination of the input channels with a timing
condition. The pattern search is only available for analog channel sources (Ch1 to
Ch4).
Pattern
Pattern search settings are the same as for the pattern trigger.
See also "Pattern" on page 256.
Search setup