Rohde & Schwarz RTE Series - Filter

Remote control commands
R&S
®
RTE
1754User Manual 1326.1032.02 ─ 20
Setting parameters:
<Frame>
<Field>
<Operator> ANY | OFF | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | RANGe
ANY = OFF
The index of the required pattern is not relevant.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
This condition requires one endpoint value to be set using
TRIGger<m>:CMSB:ADVanced:IMIN.
INRange | RANGe
This condition requires a range of endpoint values to be set
using TRIGger<m>:CMSB:ADVanced:IMAX and
TRIGger<m>:CMSB:ADVanced:IMIN.
Usage:
Setting only
18.17.15.3 Filter
BUS<m>:CMSB:FILTer:BIT........................................................................................... 1754
BUS<m>:CMSB:FILTer:DMAX.......................................................................................1755
BUS<m>:CMSB:FILTer:DMIN........................................................................................1755
BUS<m>:CMSB:FILTer:DOPerator.................................................................................1755
BUS<m>:CMSB:FILTer:ENABle.....................................................................................1756
BUS<m>:CMSB:FILTer:ERENable.................................................................................1756
BUS<m>:CMSB:FILTer:ERRor<n>:ENABle.....................................................................1756
BUS<m>:CMSB:FILTer:FIENable...................................................................................1756
BUS<m>:CMSB:FILTer:FRAMe<n>:ENABle................................................................... 1757
BUS<m>:CMSB:FILTer:FRENable................................................................................. 1757
BUS<m>:CMSB:FILTer:IMAX........................................................................................ 1757
BUS<m>:CMSB:FILTer:IMIN......................................................................................... 1758
BUS<m>:CMSB:FILTer:IOPerator.................................................................................. 1758
BUS<m>:CMSB:FILTer:BIT <Frame>, <Field>, <Bit>
Sets the bit state of a field to be filtered on that only consists of one bit.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Bit> ONE | ZERO | DC
Usage: Setting only
Protocols