Rohde & Schwarz RTE Series - S.o.a

Remote control commands
R&S
®
RTE
1963User Manual 1326.1032.02 ─ 20
POWer:SLEWrate:RESult:STDDev? <MeasType>
POWer:SLEWrate:RESult:WFMCount? <MeasType>
Return the specified statistic result of the specified measurement type.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
Query parameters:
<MeasType> MIN | MAX
Usage: Query only
18.20.10
S.O.A
POWer:SOA:EXECute..................................................................................................1963
POWer:SOA:LINear:ADD..............................................................................................1963
POWer:SOA:LOGarithmic:ADD..................................................................................... 1963
POWer:SOA:LINear:COUNt?........................................................................................ 1964
POWer:SOA:LOGarithmic:COUNt?................................................................................1964
POWer:SOA:LINear:REMove........................................................................................1964
POWer:SOA:LOGarithmic:REMove................................................................................1964
POWer:SOA:LINear:INSert........................................................................................... 1964
POWer:SOA:LOGarithmic:INSert...................................................................................1964
POWer:SOA:LINear:POINt<m>:CURRent...................................................................... 1964
POWer:SOA:LOGarithmic:POINt<m>:CURRent..............................................................1964
POWer:SOA:LINear:POINt<m>:VOLTage.......................................................................1964
POWer:SOA:LOGarithmic:POINt<m>:VOLTage...............................................................1964
POWer:SOA:MASK......................................................................................................1965
POWer:SOA:REPort:ADD.............................................................................................1965
POWer:SOA:SCALe.....................................................................................................1965
POWer:SOA:SWITch....................................................................................................1965
POWer:SOA:EXECute
Starts the safe operating area measurement.
Usage:
Event
POWer:SOA:LINear:ADD
POWer:SOA:LOGarithmic:ADD
Adds a point.
Usage:
Event
Power analysis (option R&S RTE-K31)