Rohde & Schwarz RTE Series - Waveform Histogram Export to File

Remote control commands
R&S
®
RTE
1407User Manual 1326.1032.02 ─ 20
The raw export of interleaved X/Y values is not supported.
Parameters:
<RawValues> ON | OFF
*RST: OFF
Example: See:
"Exporting raw data of a single waveform to BIN file"
on page 1062
"Exporting raw data of a measurement gate to BIN file"
on page 1063
Usage: Asynchronous command
EXPort:WAVeform:DISPlayoff
<FastExport>
Enables or disables the display update during an Nx Single acquisition.
Parameters:
<FastExport> ON | OFF
ON: Disables the display update for maximum export speed.
OFF: Enables the display update. The export is slower.
*RST: OFF
Usage: Asynchronous command
EXPort:WAVeform:FASTexport <Enable>
To improve the performance of data export to file, the measurements are performed
slower while the data export speeds up.
Setting parameters:
<Enable> ON | OFF
Example: See Chapter 18.3.5.2, "Exporting waveform data to file",
on page 1061
Usage: Setting only
Asynchronous command
18.16.6 Waveform histogram export to file
EXPort:HISTogram:SELect............................................................................................1407
EXPort:HISTogram:INCidence.......................................................................................1408
EXPort:HISTogram:NAME.............................................................................................1408
EXPort:HISTogram:SAVE..............................................................................................1408
EXPort:HISTogram:DATA?............................................................................................1408
EXPort:HISTogram:SELect <Name>
Selects the histogram to be exported.
Data management