Measurements
R&S
®
RTE
335User Manual 1326.1032.02 ─ 20
See: "To start a measurement with the [MEAS] key" on page 335.
●
Using the "Meas" menu.
See: Chapter 8.2.1.2, "Configuring measurements", on page 335.
To start a measurement using the toolbar icon
1. Select the waveform that you want to measure.
2. Tap the "Measurement" icon on the toolbar.
3. Define the measurement range in one of these ways:
● To measure the complete waveform, tap the diagram with the waveform.
● To define a gate that limits the measurement, draw a rectangle on the screen.
The "Meas Results" are displayed.
To start a measurement with the [MEAS] key
1. Select the waveform on the screen.
2. Press the [MEAS] key.
The measurement for the selected waveform is enabled using the next available
measurement configuration. The "Meas Results" are displayed.
8.2.1.2 Configuring measurements
1.
If a measurement is already running, tap the icon in a floating result box, or
double-tap a docked result box.
If no measurement is running, open the "Meas" menu and select "Overview".
2. Select the measurement "Category", for example, "Amp/Time".
3. Tap "Source" and select the waveform to be measured.
Spectrum measurements require an FFT math waveform as measurement source.
Histogram measurements require a histogram as source.
4. Select the "Measurement type".
5. Depending on the selected measurement type, further settings can be required.
Select the "Setup" tab. On the left side of the tab, select the subtab of the config-
ured measurement. Adjust the settings.
The settings are explained in the following chapters:
● Chapter 8.2.5.2, "Settings for amplitude/time measurements", on page 355
● Chapter 8.2.6.2, "Settings for eye diagram measurements", on page 363
● Chapter 8.2.7.2, "Settings for spectrum measurements", on page 365
● Chapter 8.2.8.5, "Settings for histogram measurement", on page 375
Automatic measurements
To Next Page
Loading...
