Rohde & Schwarz RTE Series - Basic Editor; Settings in the Basic Editor

Waveform analysis
R&S
®
RTE
299User Manual 1326.1032.02 ─ 20
Remote command:
ACQuire:COUNt on page 1115
7.3.3 Basic editor
In the"Basic" editor, you can define the most common mathematical formulas without
knowing their correct syntax.
Remote command:
●
CALCulate:MATH<m>[:EXPRession][:DEFine] on page 1227
7.3.3.1 Settings in the Basic editor
Source 1 / 2.................................................................................................................299
Operator......................................................................................................................299
Noise reject................................................................................................................. 300
a / b............................................................................................................................. 300
Enable math signal......................................................................................................300
Source 1 / 2
Defines the signal source to be evaluated by the math function. Channel waveforms
can be selected.
Note: If you require other signal sources not listed here, use the formula editor provi-
ded in the "Advanced" tab. Any waveform of any input channel can be used as a
source. See: Chapter 7.3.4, "Advanced", on page 301.
Operator
Defines the type of operation to be performed on the selected signal sources. The fol-
lowing functions are available:
Note: If you require other operators not listed here, use the formula editor provided in
the ""Advanced"" tab. See: Chapter 7.3.4, "Advanced", on page 301.
"+"
Adds up the sources
"-"
Subtracts source 2 from source 1.
"x"
Multiplies source 1 by source 2.
"|x|"
Determines the absolute value of the source.
Mathematics