Rohde & Schwarz RTE Series - Custom: Manchester; NRZ Decode Results

Protocol analysis
R&S
®
RTE
795User Manual 1326.1032.02 ─ 20
This function is avalible only for array fields, see "Condition" on page 780.
"Condition"
Defining a specific index or an index range requires to set the opera-
tor to one of the following conditions: equal, in range.
"Min"
Specifies the index or sets the start value of an index range.
"Max"
Sets the end value of an index range, if "Condition" is set to "In
range".
Remote command:
BUS<m>:CMSB:FILTer:IMAX on page 1757
BUS<m>:CMSB:FILTer:IMIN on page 1758
BUS<m>:CMSB:FILTer:IOPerator on page 1758
13.14.5 Custom: Manchester / NRZ decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. In the "Protocol" dialog > "Decode" tab, enable "Decode".
2. In the "Protocol" dialog > "Display" tab, select additional result display settings:
"Show decode table" and "Show binary signals".
For a description of the display settings, see also Chapter 13.1.3, "Display",
on page 515.
The instrument captures and decodes the signal according to the standard definition
and the configuration settings.
The color-coding of the various protocol sections and errors simplifies the interpretation
of the visual display. The decode information condenses or expands, depending on the
horizontal scale. Various data formats are available to show the result values.
When the configuration of the serial bus is complete, the signal can be decoded:
1. In the "Protocol" dialog > "Decode" tab, enable "Decode".
2. In the "Protocol" dialog > "Display" tab, select additional result display settings:
"Show decode table" and "Show binary signals".
For a description of the display settings, see also Chapter 13.1.3, "Display",
on page 515.
The instrument captures and decodes the signal according to the Frame format config-
uration settings.
The color-coding of the various Cells simplifies the interpretation of the visual display.
The decode information condenses or expands, depending on the horizontal scale.
Various data formats are available to show the result values.
The Frame format configuration defines the cells and their Color scheme. The honey-
comb display applies these settings according to the following rules:
●
Each frame is displayed as a honeycomb frame with the frame type being dis-
played (in the 1
st
line of the honeycomb).
Custom: Manchester / NRZ (option R&S
RTE-K50)M