Rohde & Schwarz RTE Series - Control; Action

Triggers
R&S
®
RTE
267User Manual 1326.1032.02 ─ 20
Remote command:
TRIGger<m>:LEVel<n>:NOISe:PERDivision on page 1202
TRIGger<m>:LEVel<n>:NOISe:RELative on page 1203
Noise reject (external trigger)
Enables the noise reject for the external trigger input.
Remote command:
TRIGger<m>:ANEDge:NREJect on page 1203
Hysteresis
Displays the automatic hystersis for "Hysteresis mode" = "Auto".
6.6 Control / action
Access: [TRIGGER] > "Ctrl/Action" tab
The settings and functions of trigger control define when the instrument triggers. They
affect all trigger types and all triggers in a trigger sequence.
In addition to the settings in the dialog box, you need the [RUN CONT] and [RUN N×
SINGLE] keys on the front panel to start and stop the acquisition and thus the trigger-
ing.
The action settings define what happens when a trigger occurs. All available actions
can be initiated at the same time.
The R&S RTE can provide an external trigger signal to synchronize the measurements
of other instruments. The trigger out signal is also adjusted and enabled in the "Ctrl/
Action" tab.
Control / action