Remote control commands
R&S
®
RTE
1249User Manual 1326.1032.02 ─ 20
Parameters:
<Value> Threshold in dBm
Usage: Asynchronous command
Firmware/software: Version 2.70
CURSor<m>:PEXCursion <Value>
Defines the minimum level by which the waveform must rise or fall so that it will be
identified as a maximum or a minimum by the search functions.
Suffix:
<m>
.
The suffix is irrelevant
Parameters:
<Value> Range: 0 to 100
Increment: 1
*RST: 5
Default unit: dB
Usage: Asynchronous command
18.12 Automatic measurements
This chapter contains all remote commands to set up automatic measurements and to
analyze the measurement results.
Selection of the measurement: MEASurement<m>
With R&S RTE you can configure up to eight simultaneous measurements. In manual
operation, these eight measurements are represented by subtabs "MG1" to "MG8" in
the "Measurements" dialog box. For remote operation, the measurement is indicated
by the suffix MEAS<m>, containing the number of the measurement.
Remote control: measurement suffix <m> Manual operation: "MG" subtab
1 to 8 correspond to "MG1" to "MG8"
9, 10: do not use Not available
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
Automatic measurements
To Next Page
Loading...
