Getting started
R&S
®
RTE
95User Manual 1326.1032.02 ─ 20
7. To remove the FFT results, tap the "Delete" icon and then the spectrum waveform.
8. Close the "Measurement" results.
3.3.8 Performing mathematical calculations
In addition to the measured waveforms, you can display calculated data to compare
the current measurement result with.
For example, you can rescale the waveform and display it in the same diagram as the
original waveform.
1. Press [AUTOSET].
2. Press the [MATH] key.
3. In the "Setup" tab, select the "Basic" subtab.
4. Tap the "Source1" icon and select Ch1.
5. Tap the "Operator" icon and select Rescale.
6. For "a", enter the vertical scaling factor, e.g. 4.
Trying out the instrument
To Next Page
Loading...
