Rohde & Schwarz RTE Series - Zooming for Details

Waveform analysis
R&S
®
RTE
284User Manual 1326.1032.02 ─ 20
Remote command:
LAYout:ZOOM:POSCoupling on page 1213
Horizontal
Defines whether absolute or relative values are used to specify the x-axis values.
Remote command:
LAYout:ZOOM:HORZ:MODE on page 1213
SEARch:RESDiagram:HORZ:MODE on page 1385
Position / Relative position (horizontal)
Defines the x-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:POSition on page 1214
LAYout:ZOOM:HORZ:RELative:POSition on page 1215
SEARch:RESDiagram:HORZ:ABSolute:POSition on page 1384
SEARch:RESDiagram:HORZ:RELative:POSition on page 1385
Range / Relative Range (vertical)
Defines the width of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:SPAN on page 1214
LAYout:ZOOM:HORZ:RELative:SPAN on page 1215
SEARch:RESDiagram:HORZ:ABSolute:SPAN on page 1384
SEARch:RESDiagram:HORZ:RELative:SPAN on page 1385
7.1.3 Zooming for details
The usage of the various zoom methods is described in the following procedures:
●
Chapter 3.3.4.2, "Using the fingertip zoom", on page 83
●
To define the zoom area graphically on the touchscreen
●
To define the zoom area numerically using start-stop values
●
To define the zoom area numerically using position and range values
●
To define multiple zoom areas
●
To define coupled zoom areas
●
To close the zoom diagram
●
To use the hardware zoom
To define the zoom area graphically on the touchscreen
For graphical zooming, you use your finger on the screen.
1. On the toolbar, tap the "Standard Zoom" icon.
Zoom