Rohde & Schwarz RTE Series - Scaling

Remote control commands
R&S
®
RTE
1222User Manual 1326.1032.02 ─ 20
REFCurve<m>:UPDate
Copies the selected source waveform (see REFCurve<m>:SOURce on page 1220)
with all its settings to the memory of the reference waveform.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
REFCurve<m>:SAVE
Saves the reference waveform to the file selected by REFCurve<m>:NAME
on page 1221.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
REFCurve<m>:DELete
Deletes the reference waveform file selected by REFCurve<m>:NAME on page 1221.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
REFCurve<m>:CLEar
The selected reference waveform is no longer displayed, its memory is deleted.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
Asynchronous command
18.10.2.2 Scaling
REFCurve<m>:RESCale:VERTical:STATe...................................................................... 1223
REFCurve<m>:RESCale:VERTical:OFFSet....................................................................1223
REFCurve<m>:RESCale:HORizontal:STATe...................................................................1223
REFCurve<m>:RESCale:HORizontal:OFFSet.................................................................1224
Waveform analysis