Measurements
R&S
®
RTE
326User Manual 1326.1032.02 ─ 20
Optionally, define a peak excursion. Peak excursion is the minimum level value by
which the waveform must rise or fall so that it is identified as a maximum or a mini-
mum by the search functions.
10. Tap the "Enable" icon in the "Setup" tab to activate the cursor measurement.
The cursors lines and the results are displayed. For details on cursor measurement
results, see Chapter 8.1.1, "Cursors and results of cursor measurements",
on page 322.
8.1.2.3 Configuring the cursor display
By default, the cursors are displayed as lines in the diagrams and labeled according to
the syntax: C<cursor set number>.<1|2>
For example, the cursors for the cursor set 2 are labeled 2.1 and 2.2. The horizontal
and the vertical cursors lines have the same labels.
You can change the default cursor display and labels.
To set the cursor style
1. Press the [CURSOR] key.
2. Select the subtab for the cursor set you want to configure.
3. Select the "Setup" tab.
4. Select the cursor style. See also: "Cursor style" on page 328.
To add labels to cursor lines
1. Press the [CURSOR] key.
2. Select the subtab for the cursor set you want to configure.
3. Select the "Label / Display" tab.
4. For each vertical and horizontal cursor, enter a label.
5. Select "Show labels".
8.1.2.4 Saving measurement results to file
► Tap "Result export" in the "Cursors" > "Setup" tab.
See also: Chapter 12.2.4, "Numeric Results", on page 492.
8.1.3 Settings for cursor measurements
Cursor measurements are configured in the "Cursors" dialog box.
Cursor measurements
To Next Page
Loading...
