Rohde & Schwarz RTE Series - General Remote Settings

Remote control commands
R&S
®
RTE
1081User Manual 1326.1032.02 ─ 20
Reads the contents of the status byte in decimal form.
Usage: Query only
*TRG
Trigger
Triggers all actions waiting for a trigger event. In particular, *TRG generates a manual
trigger signal. This common command complements the commands of the TRIGger
subsystem.
Usage: Event
*TST?
Self-test query
Initiates self-tests of the instrument and returns an error code.
Return values:
<ErrorCode> integer > 0 (in decimal format)
An error occurred.
(For details, see the Service Manual supplied with the instru-
ment).
0
No errors occurred.
Usage: Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
Event
18.6 General remote settings
This chapter describes commands that have effect on many other remote commands
in different applications of the instrument.
FORMat[:DATA]........................................................................................................... 1082
FORMat:BORDer.........................................................................................................1083
FORMat:BPATtern........................................................................................................1083
SYSTem:DISPlay:UPDate.............................................................................................1084
SYSTem:KLOCk.......................................................................................................... 1084
GPIB:ADDRess........................................................................................................... 1084
General remote settings