Rohde & Schwarz RTE Series - General Settings

Remote control commands
R&S
®
RTE
1250User Manual 1326.1032.02 ─ 20
●
Chapter 18.3, "Programming examples", on page 1054
● General settings..................................................................................................1250
● Results................................................................................................................ 1254
● Amplitude/time measurements............................................................................1257
● Eye diagram measurements............................................................................... 1266
● Spectrum.............................................................................................................1269
● Histograms..........................................................................................................1277
● Display................................................................................................................ 1287
● Statistics and long-term measurements..............................................................1289
● Protocol...............................................................................................................1295
● Track and trend................................................................................................... 1301
● Gating..................................................................................................................1302
● Limit check and event actions.............................................................................1305
● Reference levels................................................................................................. 1308
18.12.1 General settings
MEASurement<m>[:ENABle].........................................................................................1250
MEASurement<m>:SOURce.........................................................................................1250
MEASurement<m>:FSRC.............................................................................................1251
MEASurement<m>:SSRC.............................................................................................1252
MEASurement<m>:CATegory........................................................................................1252
MEASurement<m>:MAIN..............................................................................................1253
MEASurement<m>[:ENABle] <State>
Switches the indicated measurement on or off.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<State> ON | OFF
*RST: OFF
Example: See "Simple frequency and amplitude measurement"
on page 1057.
Usage: Asynchronous command
MEASurement<m>:SOURce <SignalSource>, [<SignalSource2>]
Defines the source of the measurement. Availability of sources depends on the
selected category and installed options.
Automatic measurements