Rohde & Schwarz RTE Series - Eye Diagram Measurements

Remote control commands
R&S
®
RTE
1266User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
<n> 1..50
Number of the amplitude/time measurement, see Table 18-5.
Parameters:
<UpperLimit> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin
<LowerMargin>
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin <UpperMargin>
Define the lower and upper margins for the limit check, respectively. Margins are not as
strict as limits and must be within the valid value range. The valid range is defined
using the MEASurement<m>:AMPTime:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
<n> 1..50
Number of the amplitude/time measurement type, see
Table 18-5.
Parameters:
<UpperMargin> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
18.12.4 Eye diagram measurements
The following table lists the <MeasType> parameter values with a short description.
In addition, the suffixes <n> for limit check remote commands are listed.
For a detailed description, see Chapter 8.2.6.1, "Overview of eye diagram measure-
ments", on page 361.
Automatic measurements