Rohde & Schwarz RTE Series - Measurement Results

Measurements
R&S
®
RTE
337User Manual 1326.1032.02 ─ 20
Remote command:
MEASurement<m>[:ENABle] on page 1250
Category
Measurement category. The following categories are available:
Time domain:
●
Amp/Time: amplitude and time measurements
●
Eye: eye diagram measurements
●
Histogram: measurements on histograms
●
Protocol: available for audio signals (option R&S RTE-K5)
Protocol: advanced analysis (available if option R&S RTE-K35 is installed)
Frequency domain
●
Spectrum: measurements on spectrum waveforms
●
Histogram: measurements on histograms
Remote command:
MEASurement<m>:CATegory on page 1252
Source, 2nd Source
Define the source of the measurement. The 2nd source is required for amplitude/time
measurements that are performed on two waveforms (e.g. delay, phase). Availability of
sources depends on the selected category and installed options.
Remote command:
MEASurement<m>:SOURce on page 1250
Measurement type
Defines the measurement type for the selected measurement and category.
For details on the available measurement types, see:
●
Chapter 8.2.5.1, "Overview of amplitude/time measurements", on page 349
●
Table 8-5
●
Table 8-6
●
Table 8-7
Remote command:
MEASurement<m>:MAIN on page 1253
Statistics / Enable
Enables the calculation and display of statistical results.
Remote command:
MEASurement<m>:STATistics[:ENABle] on page 1289
8.2.2 Measurement results
By default, the results of automatic measurements are displayed below the waveform
diagram when an automatic measurement is enabled.
Automatic measurements