Rohde & Schwarz RTE Series - ARINC Search Results

Protocol analysis
R&S
®
RTE
690User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:ARINc:ERRor:CODing on page 1644
SEARch:TRIGger:ARINc:ERRor:PARity on page 1645
SEARch:TRIGger:ARINc:ERRor:TIMing on page 1645
13.10.6.2 ARINC search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
Figure 13-51: Results of a general "Label +data" search with applied label list. All frames are found
that contain any label, any data, and any SDI/SSM bits.
Remote commands:
●
SEARch:RESult:ARINc:WCOunt? on page 1647
●
SEARch:RESult:ARINc:WORD<m>:DATA? on page 1646
ARINC 429 (option R&S
RTE-K7)