Getting started
R&S
®
RTE
96User Manual 1326.1032.02 ─ 20
7. Under "b", enter the vertical position offset, e.g. 2.
Look at the lower part of the dialog box and note that the instrument adjusts the
"Vertical scale" and "Vertical offset" of the math waveform automatically.
8. Tap "Enable" to display the first math waveform.
The original and the rescaled waveforms are displayed.
9. Close the "Math" dialog box.
10. To remove the math waveform, do one of the following:
● Tap the "Delete" icon and then the math waveform.
● Minimize the math waveform by tapping the signal icon. Then close the signal
icon
3.3.9 Performing a search
In the following search, you detect positive and negative overshoots, i.e. values that
exceed the high or low levels. To find these events, you can use the windows search.
To determine the search conditions, we use the results of the measurement example
described in Chapter 3.3.6.3, "Performing and configuring the quick measurement",
on page 89.
Trying out the instrument
To Next Page
Loading...
