Getting started
R&S
®
RTE
70User Manual 1326.1032.02 ─ 20
[LEVELS]
The rotary knob sets the trigger level for all trigger types. Turn clockwise to move up
the trigger level. If the selected trigger type requires two trigger levels - upper and
lower level - press the knob to toggle between the two levels.
[SOURCE]
Opens a dialog box where you can select the trigger source. Press the key again to
switch the source. The key lights up in the color of the selected trigger source.
[SLOPE]
Toggles the trigger slope or trigger polarity, dependent on the trigger type. The current
setting is shown on the trigger label, which is in the upper part of the signal bar.
[MODE]
Toggles the trigger mode between Auto and Normal. The current setting is shown on
the trigger label.
[RUN CONT]
Starts and stops the continuous acquisition. A green light indicates a running acquisi-
tion. A red light shows that acquisition is stopped.
[RUN N× SINGLE]
Starts a defined number of acquisitions. A green light indicates a running acquisition. A
red light shows that acquisition is stopped. Press the key again to stop running acquisi-
tions.
To set the number of acquisitions, press the [TRIGGER] key, select the "Ctrl/Action"
tab, and set "Average count (N-single count)".
3.2.3.6 ANALYSIS keys
The keys in the ANALYSIS functional block provide direct access to measurement and
analyzing functions. If you press [CURSOR], [ZOOM] or [MEAS], the action starts on
first keypress, and a second keypress opens the corresponding dialog box. If you
press another function key, the dialog box opens.
[CURSOR]
Displays vertical and horizontal cursors in the active diagram and opens the "Cursor
Results" box.
Cursors are markers which are placed at points of interest on a waveform. The instru-
ment measures the cursor positions and delta values between parallel cursors.
If you press the key while a cursor measurement is enabled, the "Cursors" dialog box
opens.
Instrument tour
To Next Page
Loading...
