Rohde & Schwarz RTE Series - I²C Search Results

Protocol analysis
R&S
®
RTE
538User Manual 1326.1032.02 ─ 20
Address OR setup: , Monitor Address type, Address, R/W bit
The address OR setup consists of the monitor, address type, address and an R/W bit.
The address OR setup settings are the same as in the I2C trigger setup, see Chap-
ter 13.2.3.1, "I²C trigger settings", on page 526.
Remote command:
SEARch:TRIGger:I2C:ADDO<m>:ENABle on page 1447
SEARch:TRIGger:I2C:ADDO<m>:ADRType on page 1447
SEARch:TRIGger:I2C:ADDO<m>[:VALue] on page 1448
SEARch:TRIGger:I2C:ADDO<m>:RWBit on page 1448
No ACK setup: Addr/W/R NACK
The no ACK setup consists of the Addr/W/R NACK.
The no ACK setup settings are the same as in the I2C trigger setup, see "No Ack con-
ditions" on page 529.
Remote command:
SEARch:TRIGger:I2C:DRNack on page 1450
SEARch:TRIGger:I2C:DWNack on page 1451
SEARch:TRIGger:I2C:NACKnowledge on page 1444
13.2.6.2 I²C search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
I²C (option R&S
RTE-K1)