Rohde & Schwarz RTE Series - Diagnostic Remote Trace Commands

Remote control commands
R&S
®
RTE
1992User Manual 1326.1032.02 ─ 20
<Error> ON | OFF
New SCPI error queue entries
<Trigger> ON | OFF
Trigger events
<DeviceClear> ON | OFF
Device clear events
<StatusRegister> ON | OFF
Status register conditions
<Connection> ON | OFF
Open/close connection events
<RemoteLocalEvents>ON | OFF
Local/remote transition events
<Locking> ON | OFF
Remote locking events
18.23.2 Diagnostic remote trace commands
TRACe:REMote:MODE:FILE:DEXecution:DURation........................................................1992
TRACe:REMote:MODE:FILE:RPC.................................................................................1992
TRACe:REMote:MODE:FILE:PARSer............................................................................ 1992
TRACe:REMote:MODE:FILE:FUNCtions........................................................................1993
TRACe:REMote:MODE:FILE:DEXecution:DURation <Enable>
Traces the device execution time of a command
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:RPC <Enable>
Enables and disables output of rpc calls to remote trace.
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:PARSer <Enable>
Enables and disables output of parser transitions to remote trace.
Parameters:
<Enable> ON | OFF
Remote trace