Measurements
R&S
®
RTE
376User Manual 1326.1032.02 ─ 20
"Upper Peak"
The y-value at the maximum sample value in the upper half of the
histogram
"Lower Peak"
The y-value at the maximum sample value in the lower half of the his-
togram
"Maximum"
The highest y-value with a probability > 0
"Minimum"
The lowest y-value with a probability > 0
"Median"
The y-value for which half the samples lie above, the other half below
in the histogram.
"Mean"
The weighted arithmetic average of the histogram
Remote command:
MEASurement<m>:HISTogram:PROBability:TYPE on page 1284
Probability domain marker, Delta
Defines a range around the marker.
Remote command:
MEASurement<m>:HISTogram:PROBability:LIMit on page 1285
8.2.9 Protocol measurements (option R&S RTE-K35)
Option R&S RTE-K35 provides specific measurements on automotive and Ethernet
protocols.
8.2.9.1 Overview of protocol measurements
If option R&S RTE-K35 is installed, enhanced measurements on the supported serial
buses are possible. With it, you can measure various dependencies between the
frames.
Additional to option R&S RTE-K35 you need one of the following serial protocol
options:
●
I2C (R&S RTE-K1)
●
SPI (R&S RTE-K1)
●
UART/RS232 (R&S RTE-K2)
●
CAN / CAN-FD (R&S RTE-K3/R&S RTE-K9)
●
LIN (R&S RTE-K3)
●
RFFE (R&S RTE-K40)
●
SENT (R&S RTE-K10)
●
Ethernet (100BASE-Tx) (R&S RTE-K8)
●
100BASE-T1 (R&S RTE-57)
Automatic measurements
To Next Page
Loading...
