Rohde & Schwarz RTE Series - USBPD Search Results

Protocol analysis
R&S
®
RTE
860User Manual 1326.1032.02 ─ 20
You can define individual search parameters for individual fields in the table below the
"Search criteria" dialog. To specify these parameters, select a field in this table and
define the data and/or index operators and values, or the bit state.
For a description of how to set the search conditions, see Chapter 13.17.3.1, "USBPD
trigger settings", on page 853.
Remote command:
SEARch:TRIGger:USBPd:ERENable on page 1845
SEARch:TRIGger:USBPd:ERRor<m>:ENABle on page 1845
SEARch:TRIGger:USBPd:BIT on page 1847
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:BIT on page 1847
SEARch:TRIGger:USBPd:DMAX on page 1847
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:DMAX on page 1847
SEARch:TRIGger:USBPd:DMIN on page 1848
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:DMIN on page 1848
SEARch:TRIGger:USBPd:DOPerator on page 1848
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:DOPerator on page 1848
SEARch:TRIGger:USBPd:IMAX on page 1849
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:IMAX on page 1849
SEARch:TRIGger:USBPd:IMIN on page 1849
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:IMIN on page 1849
SEARch:TRIGger:USBPd:IOPerator on page 1849
SEARch:TRIGger:USBPd:FRAMe<m>:FLD<n>:IOPerator on page 1849
13.17.5.2 USBPD search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog to better see the "Search Results" table.
If the "Show decode detail" field in the "Configuration" tab of the protocol setup is
enabled, then the "Enable" search button is disabled. Disable "Show decode detail"
first, to be able to start the search.
USBPD (option R&S RTE-K63)