Rohde & Schwarz RTE Series - Trigger

Remote control commands
R&S
®
RTE
1706User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<FrameLength> Range: 104 to 922
Increment: 1
*RST: 256
18.17.14.2 Trigger
Event in a trigger sequence: 1 = A-event only
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:SENT:TYPE.............................................................................................1706
TRIGger<m>:SENT:TTYPe........................................................................................... 1707
TRIGger<m>:SENT:STATus.......................................................................................... 1707
TRIGger<m>:SENT:TDCN............................................................................................ 1708
TRIGger<m>:SENT:TDMN............................................................................................1708
TRIGger<m>:SENT:TDMX............................................................................................ 1708
TRIGger<m>:SENT:STYPe...........................................................................................1708
TRIGger<m>:SENT:SIDType.........................................................................................1709
TRIGger<m>:SENT:SICN..............................................................................................1709
TRIGger<m>:SENT:SIMN............................................................................................. 1709
TRIGger<m>:SENT:SIMX............................................................................................. 1710
TRIGger<m>:SENT:SDCN............................................................................................ 1710
TRIGger<m>:SENT:SDMN............................................................................................1710
TRIGger<m>:SENT:SDMX............................................................................................1710
TRIGger<m>:SENT:FORMerror.....................................................................................1710
TRIGger<m>:SENT:PULSeerror.................................................................................... 1711
TRIGger<m>:SENT:PPERioderror..................................................................................1711
TRIGger<m>:SENT:CRCerror........................................................................................1711
TRIGger<m>:SENT:IRFLength...................................................................................... 1712
TRIGger<m>:SENT:TYPE <Type>
Selects the trigger event for the SENT transmission type.
Parameters:
<Type> CALI | TSEQ | SMSG | ERRC
CALI
CALIbration: triggers on the falling edge of the calibration/
synchronization pulse.
Protocols