Rohde & Schwarz RTE Series - Search Gate Settings

Remote control commands
R&S
®
RTE
1379User Manual 1326.1032.02 ─ 20
CURSor<m>:THReshold <Value>
Defines an absolute threshold as an additional condition for the peak search. Only
peaks that exceed the threshold are detected.
Suffix:
<m>
.
The suffix is irrelevant.
Parameters:
<Value> Threshold in dBm
Usage: Asynchronous command
Firmware/software: Version 2.70
18.15.15
Search gate settings
SEARch:GATE[:STATe].................................................................................................1379
SEARch:GATE:MODE..................................................................................................1379
SEARch:GATE:SHOW..................................................................................................1380
SEARch:GATE:ABSolute:STARt....................................................................................1380
SEARch:GATE:ABSolute:STOP.................................................................................... 1380
SEARch:GATE:RELative:STARt.................................................................................... 1380
SEARch:GATE:RELative:STOP.....................................................................................1381
SEARch:GATE:ZCOupling............................................................................................ 1381
SEARch:GATE:ZDIagram............................................................................................. 1381
SEARch:GATE[:STATe] <SearchName>,<State>
SEARch:GATE[:STATe]? <SearchName>
Performs the search only on the defined gate area of the source waveform.
Parameters:
<State> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:MODE <SearchName>,<Mode>
SEARch:GATE:MODE? <SearchName>
Defines whether the gate settings are configured using absolute or relative values.
Parameters:
<Mode> ABS | REL
*RST: ABS
Parameters for setting and query:
<SearchName> Search definition
Search