Rohde & Schwarz RTE Series - Amplitude Measurements

Measurements
R&S
®
RTE
350User Manual 1326.1032.02 ─ 20
The R&S RTE provides various voltage, time, area and counting measurements in the
category "Amp/Time". Some measurements require reference levels to be set accord-
ing to the measurement purpose.
Reference levels are explained in Chapter 8.2.4, "Reference levels", on page 344.
● Amplitude measurements..................................................................................... 350
● Time measurements............................................................................................. 352
● Area measurements..............................................................................................354
● Counting................................................................................................................354
Amplitude measurements
Access: "Meas" menu > "Setup" > "Amp/Time" category
Table 8-1: Amplitude measurement types
Meas. type Symbol Description/Result
High X
High
High signal level
Low X
Low
Low signal level
Amplitude X
Ampl
Amplitude of the signal: the difference of high and low signal lev-
els
X
Ampl
= X
High
- X
Low
Max X
Max
Absolute maximum value of the waveform
Min X
Min
Absolute minimum value of the waveform
Automatic measurements