Measurements
R&S
®
RTE
396User Manual 1326.1032.02 ─ 20
8.3 Quick measurements
Quick measurement performs a set of up to eight amplitude/time measurements on
one source, simply by tapping the "Quick measurement" toolbar icon. The results are
displayed in a results box. You can configure the measurement type to be included in
quick measurement. The current configuration can be saved to repeat the measure-
ment quickly.
8.3.1 Starting the quick measurement
If the "Quick meas" icon is not visible on the toolbar, add it to the toolbar: see Chap-
ter 3.4.7.2, "Configuring the toolbar", on page 119.
1. Tap the waveform that you want to measure.
2. Tap the "Quick measurement" icon on the toolbar.
3. Tap the diagram.
The result box shows the results of the default quick measurement.
8.3.2 Configuring the quick measurement
The default configuration of the quick measurement includes already 8 amplitude mea-
surements. If these measurements do not fit the measurement task, you can modify
the selection.
1. On the "Meas" menu, select "Setup".
2. Under "Quick Measurement", tap "Setup".
3. In the list of active measurements, disable all measurements that you do not need.
Quick measurements
To Next Page
Loading...
