Rohde & Schwarz RTE Series - Data2 Clock

Remote control commands
R&S
®
RTE
1183User Manual 1326.1032.02 ─ 20
TRIGger<m>:SLEW:DELTa <TimeDelta>
Defines a time range around the slew rate specified using TRIGger<m>:SLEW:RATE.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Parameters:
<TimeDelta> Range: 0 to 10
Increment: 100E-9
*RST: 0
Default unit: s
Usage: Asynchronous command
18.9.10 Data2Clock
The Data2Clock trigger is only available for the A-event (Suffix = 1).
TRIGger<m>:DATatoclock:CSOurce[:VALue]...................................................................1183
TRIGger<m>:DATatoclock:CSOurce:EDGE.....................................................................1183
TRIGger<m>:DATatoclock:CSOurce:LEVel..................................................................... 1184
TRIGger<m>:SCOupling...............................................................................................1184
TRIGger<m>:DATatoclock:HTIMe.................................................................................. 1184
TRIGger<m>:DATatoclock:STIMe...................................................................................1185
TRIGger<m>:DATatoclock:CSOurce[:VALue] <ClockSource>
Selects the source of the clock signal.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<ClockSource> CHAN1 | CHANnel1 | CHAN2 | CHANnel2 | CHAN3 |
CHANnel3 | CHAN4 | CHANnel4
CHAN1 = CHANnel1, CHAN2 = CHANnel2, CHAN3 = CHAN-
nel3, CHAN4 = CHANnel4
Input channel of the clock signal
*RST: CHAN1
Usage: Asynchronous command
TRIGger<m>:DATatoclock:CSOurce:EDGE <ClockEdge>
Sets the edge of the clock signal to define the time reference point for the setup and
hold time.
Trigger