Rohde & Schwarz RTE Series - Output Spectrum Settings

Power analysis (option R&S RTE-K31)
R&S
®
RTE
1020User Manual 1326.1032.02 ─ 20
You can tap on a cursor and change its position with the [NAVIGATION] rotary
knob.
On the screen, you can see the measurement of the spectrum. Also, the result box
shows the position of the peaks. For details, see Chapter 16.6.3.1, "Output spec-
trum results", on page 1018.
16.6.3.3 Output spectrum settings
In the "Channels" tab, you set the voltage source, see also: Chapter 16.2.1, "Channels
tab", on page 965.
In the "Settings" tab, you configure the spectrum measurement parameters and display
settings.
SMPS Switching frequency
Sets the SMPS switching frequency. Set the value according to your DUT.
Remote command:
POWer:SPECtrum:FREQuency on page 1981
Derived scale
Shows the scale of the displayed results. This value is calculated as the inverse of the
"SMPS switching frequency"
Optimize scaling
Selects the scaling for the display of the results.
"Autoscale the signals"
Automatically selects the most appropriate scale for the display of the
results.
"Keep present settings"
The present display settings are not changed.
Remote command:
POWer:SPECtrum:AUToscale on page 1981
Output